Filter
Top Products
Administration
Email Alert
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 33
3
Emergency, Alert, Critical, Error, Warning, Notice, Info, and Debug. If set to
None, then no scheduled severity messages are sent. The default severity is
Warning.
• Urgent Message Severity—Log messages of this severity level or higher
are sent to the configured email address immediately. Select from these
values: None, Emergency, Alert, Critical, Error, Warning, Notice, Info, and
Debug. If set to None, then no urgent severity messages are sent. The default
is Alert.
STEP 3 In the Mail Server Configuration area, configure these parameters:
• Server IPv4 Address/Name—Enter the IP address or hostname of the
outgoing SMTP server. (You can check with your email provider for the
hostname.) The server address must be a valid IPv4 address or hostname.
The IPv4 address should be in a form similar to xxx.xxx.xxx.xxx (192.0.2.10).
A hostname can consist of one or more labels, which are sets of up to 63
alphanumeric characters. If a hostname includes multiple labels, each is
separated by a period (.). The entire series of labels and periods can be up
to 253 characters long.
• Data Encryption—Enter the mode of security for the outbound email alert.
The alert can be sent using secure TLS protocol or the default Open
protocol. Using secure TLSv1 protocol can prevent eavesdropping and
tampering during the communication across the public network.
• Port—Enter the SMTP port number to use for outbound emails. The range is
a valid port number from 0 to 65535. The default port is 465. The port
generally depends on the mode used by the email provider.
• Username—Enter the username for the email account that will be used to
send these emails. Typically (but not always) the username is the full email
address including the domain (such as Name@example.com). The specified
account will be used as the email address of the sender. The username can
be from 1 to 64 alphanumeric characters.
• Password—Enter the password for the email account that will be used to
send these emails. The password can be from 1 to 64 characters.
STEP 4 Configure the email addresses and subject line.
• To Email Address 1/2/3—Enter up to three addresses to receive email
alerts. Each email address must be valid.
• Email Subject—Enter the text to appear in the email subject line. This can be
up to a 255 character alphanumeric string.