Filter
Top Products
Single Point Setup
Wireless Neighborhood
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 166
10
If there is only one WAP device in the cluster, only a single IP address
column shows, indicating that the WAP device is grouped with itself.
You can click on an IP address to view more details on a particular WAP
device.
• Neighbors—Devices that are neighbors of one or more of the clustered
devices are listed in the left column by SSID (network name).
A device that is detected as neighbor can also be a cluster member itself.
Neighbors who are also cluster members are always shown at the top of the list
with a heavy bar above and include a location indicator.
The colored bars to the right of each WAP device in the Neighbors list shows the
signal strength for each of the neighbor WAP devices, as detected by the cluster
member whose IP address is shown at the top of the column.
The color of the bar indicates the signal strength:
• Dark Blue Bar—A dark blue bar and a high signal strength number (for
example 50) indicates good signal strength detected from the neighbor, as
seen by the device whose IP address is listed above that column.
• Lighter Blue Bar—A lighter blue bar and a lower signal strength number (for
example 20 or lower) indicates medium or weak signal strength from the
neighbor, as seen by the device whose IP address is listed above that
column
• White Bar—A white bar and the number 0 indicates that a neighboring
device that was detected by one of the cluster members cannot be
detected by the device whose IP address is listed above that column.
• Light Gray Bar—A light gray bar and no signal strength number indicates
that no signal has been detected from the neighbor, but the neighbor may
have been detected by other members of the cluster.
• Dark Gray Bar—A dark gray bar and no signal strength number indicates
the WAP device itself that corresponds to the IP address listed above it. A
signal strength of zero is displayed because the device’s own signal
strength is not measured.
To view details on a cluster member, click the IP address of a member at the top of
the page.
The following details for the device appear below the Neighbors list.
• SSID—The Service Set Identifier for the neighboring access point.