Filter
Top Products
Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the VPN Settings
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 109
5
STEP 3 Configure the settings in the following sections of the VPN > IPSec VPN window:
• Setting Up Local Groups on page 110
• Setting Up and Configuring Remote Groups on page 111
• Setting Up IPSec on page 113
STEP 4 To configure advanced settings, click Advanced.
• Aggressive Mode—There are two types of Phase 1 exchanges: Main mode
and Aggressive mode. Aggressive Mode requires half of the main mode
messages to be exchanged in Phase 1 of the SA exchange. If network
security is preferred, select Main mode.
• NetBIOS broadcast—Check the box to enable NetBIOS traffic to pass
through the VPN tunnel. By default, WRVS4400N blocks these broadcasts.
STEP 5 Click Save.
STEP 6 To establish a connection for the current VPN tunnel, click Connect.
To break the connection, click Disconnect.
STEP 7 To view the VPN log, which shows details of each tunnel established, click View
Log.