Filter
Top Products
- 220 -
DLE DC4 fn m t （Specification of fn = 1）
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Outputting specified pulse in real-time
[Code] <10>H<14>H<fn><d1> …<d7>
[Range] fn=1、m=1、2 t=d3=20、d4=1、d5=6、d6=2、d7=8
[Outline] [The specification which depend on the model]
• A signal specified with “t” is output to the connector pin specified with “m”.
m Connector Pin
0 Pin No. 2 of drawer kick-out connector
1 Pin No. 5 of drawer kick-out connector
• Set the ON time/OFF time to t x100 ms, respectively.
[Caution] • If another data string of <10>H<04>H<n> (1 n 4) is received, the printer acts the same way as
with this command. Therefore, the user should be reminded of this fact.
[Example 1]
Suppose a command “ESC * m nL nH [d1 ... dk]”, where d1 = <10>H, d2 = <04>H, d3 = <01>H.
• The DLE EOT n command cannot be interleaved into the code string of another command
consisting of 2 bytes or more.
[Example 2]
If the printer sends DLE EOT 3 after the host has sent up to ESC 3 in its attempt to send ESC 3 n,
the printer handles the ESC 3 as ESC 3 <10>H. Thus, the user should be cautious.
• This command is ignored under the following conditions.
• During sending block data
• During output of signal to drawer kick connector
• During occurrence of error
[See Also] ESC p