Filter
Top Products
- 67 -
ESC
＼
nL nH
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Specifying the relative position
[Code] <1B>H<5C>H<nL><nH>
[Range] 0≦nL≦255
0≦nH≦255
[Outline] [The specification which is common to the model]
This command specifies the next print start position in a relative position with respect to the current
position. The next print start position will be at a point of [(nL+nH×256)×basic calculation pitch]
inches away from the current position.
[Caution] • Specification of a position outside the print area is ignored.
• If a new position is specified to the right of the current position in the direction of printing, it should
be specified as positive (+). If it is to the left, it should be as negative (–).
• A negative value is the complement of 65536. For example, to move the position by N pitches to
the left, specify it as: nL + nH x 256 = 65536 – N
• Fractions resulting from calculation are corrected with the minimum pitch of the mechanism, and
the remainder is omitted.
• In STANDARD MODE, this command uses the horizontal basic calculation pitch (x).
• In PAGE MODE, this command acts differently depending on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command specifies the
relative position in the direction perpendicular to the paper feed (The character’s side-to-side
direction), using the horizontal basic calculation pitch (x).
(2) If the start point is top right or bottom left, the command specifies the relative position in the
paper feed direction (The character’s side-to-side direction), using the vertical basic calculation
pitch (y).
[See Also] ESC $、GS P
[Sample Program]
Refer to Sample Program and Print Results for ESC $.