Filter
Top Products
96
For Assistance, Call 1-800-435-7329
Error Messages
DISPLAY MESSAGE CAUSE & REMEDY
Error messages on the LCD display!
If the unit detects a problem, one or more of the following messages will appear on the display.
¡There is something wrong with the unit. Contact our service personnel (p. 122).
¡The front cover is open. Close it.
¡The document is not fed into the unit properly. Reinsert the document. If
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(p. 114). If the problem remains, adjust the feeder pressure (p. 109).
¡The film cartridge is not inserted properly. Reinsert it correctly (p. 110, 111).
¡The recording paper set lever is released. Push the lever back to reset (p. 20).
¡Memory (phone numbers, parameters, etc.) has been erased. Re-program.
¡The recording paper is not installed or the unit ran out of paper. Install paper
(p. 20).
¡The recording paper is not fed into the unit properly or has jammed near the
recording paper entrance. Clear the jammed paper (see “When paper has
jammed near the recording paper entrance” on page 108).
Do not install folded or heavily curled paper in the paper tray.
¡The unit has (a) document(s) in memory. See the other message’s instructions to
print out the document(s).
¡The film is empty. Replace the film or film cartridge with a new one (p. 110, 111).
¡The film is slack. Tighten it (see step 8 on page 111) and install again.
¡The remaining film can print approx. 15 pages of letter size documents. Prepare a
new film or film cartridge (p. 7).
¡The memory is full of received documents due to a lack of recording paper or a
recording paper jam, etc. Install paper or clear the jammed paper.
¡When performing memory transmission, the document being stored exceeds the
memory capacity of the unit. Transmit the entire document by using manual or
automatic transmission.
¡The receiving unit is busy or ran out of recording paper. Try again.
¡A recording paper is jammed under the film cartridge. Clear the jammed paper
(p. 107).
¡The fax function cannot be operated by the PC. The RS232C cable is not
connected correctly, or the software is not running on the PC.
CHECK COVER
CHECK DOCUMENT
CHECK MEMORY
MEMORY FULL
NO FAX REPLY
PAPER JAMMED
PC FAIL OR BUSY
CHECK FILM
CHECK LEVER
CHECK PAPER
FAX IN MEMORY
FILM EMPTY
FILM NEAR EMPTY
CALL SERVICE