Filter
Top Products
98
For Assistance, Call 1-800-435-7329
Operations
When a function does not work, check here before
requesting help!
CAUSE & REMEDYPROBLEM
I cannot make and receive calls.
I cannot make calls.
The main unit does not work.
The handset does not work.
The main unit does not ring.
The handset does not ring.
The REDIAL/PAUSE button does
not function properly.
The receive mode does not function
as explained on pages 56 and 57.
During programming, I cannot enter
the fax activation code or the
remote TAM activation ID.
An alarm tone sounds when you
press (TALK) or (INTERCOM).
An alarm tone sounds continuously
while using the handset.
Static, sound cuts in/out, fades.
Interference from other electrical
units.
The unit stops working during
operation.
¡The power cord or telephone line cord is not connected. Check the
connections (see page 21).
¡The dialing mode setting is wrong. Check the setting and change
to TONE or PULSE (see page 42).
¡Disconnect the unit from the telephone line and connect the line to
a known working telephone. If the working telephone operates
properly, call your service center to have the unit repaired. If the
working telephone does not operate properly, contact your
telephone company.
¡Check the settings (see pages 27 and 28).
¡Charge the battery fully (see pages 27 and 28).
¡Clean the charge contacts and charge again (see page 115).
¡The ringer volume is set to OFF. Adjust to a suitable level (see
page 29).
¡The ringer volume is set to OFF. Press (LOUD/RINGER) when the
TALK/BATT LOW indicator light is off.
¡If this button is pressed during dialing, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialed will be redialed.
¡A distinctive ringing pattern is set (see page 66).
¡Whole or part of the number is the same as another code or ID.
Change the number (see pages 62 and 68).
¡You are too far from the main unit. Move closer and try again.
¡Place the handset on the main unit and try again.
¡The power cord is disconnected. Plug in the power cord.
¡Move closer to the main unit quickly, or the call will be terminated
within 60 seconds.
¡The power cord is disconnected. Plug in the power cord.
¡Locate the handset and the main unit away from electrical
appliances.
¡Move closer to the main unit.
¡Raise the main unit antenna.
¡Press (CH) to change the channel.
¡Place the handset on the main unit and disconnect the power cord
to reset the unit. Connect the power cord, then try again.
General