Filter
Top Products
Jumpers
System Board Jumpers
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.
System-Board Jumper Settings
Back to Contents Page
PSWD
Password jumper
RIMM_n
Memory module socket
SERIALn
Serial connectors (2)
SCSI
Auxiliary hard-drive activity light connector
SPEAKER
System board speaker
STANDBY_LED
Standby power light
TELE
Telephony (TAPI) connector
USB_LAN
Network and Port 1 USB (2) connectors
NOTICE: Before changing a jumper setting, verify that the standby power light on the system board has turned off. Otherwise, damage to your
computer or unpredictable results may occur. To locate this light, see "System Board Components."
Jumper
Setting
Description
PSWD
(default)
Password features are enabled.
Password features are disabled.
CLR CM
(pins 1 and 2)
Normal setting—pins 1 and 2 are jumpered.
(pins 2 and 3)
CLR CM setting—pins 2 and 3 are jumpered. See "Reset Corrupted BIOS Settings" in your User's Guide.
jumpered unjumpered
NOTE: The CLR CM settings are also located on the system board next to the AGP card clip tab.