Filter
Top Products
Cluster Data Sheet C-3
Cluster order number: ____________________
Software and Firmware
❑ Dell PowerEdge Expandable RAID Controller cluster firmware revision: ______________________
❑ The Intel Pro100B driver revision is 2.22 or later.
❑ Cluster system configuration utility version: ____________________
❑ Windows NT Server Enterprise Edition revision: __________________
❑ xover.exe revision: ____________________
Pre-Installation Settings
❑ PowerEdge Expandable RAID Controller initiator IDs:
Node 1: ______________ and Node 2: ________________
❑ The cluster RAID controller has been configured for write-through operation.
❑ The RAID level and logical drives are configured and initialized.
❑
Cluster Mode for th
e Dell PowerEdge 4200 Cluster has been turned on in the system BIOS.
Windows NT Server Settings
❑ The RAID controller drivers are installed.
❑ A 1024-MB partition has been created for the Windows NT Server Enterprise Edition system drive.
❑ License type: _________________ Number: __________________
❑ Network name for this computer: ___________________
❑ Domain type has been chosen (Primary Domain Controller, Backup Domain Controller, or stand-alone).
❑ Administrator user name: _________________
❑ Administrator password: _________________
❑ Network participation has been wired to network.
❑ Microsoft Internet Information Server (IIS) has been installed.
❑ All network adapters have been found and accepted.
❑ Network protocol is TCP/IP only. Uncheck any others.
❑ SNMP service has been added.
❑ DHCP server is not selected.
Instructions:
Before installing the Microsoft
®
Windows NT
®
Enterprise Edition operating system with clustering, use this checklist
to gather information and ensure the preparation required for a successful installation. Ensure that all equipment is present and prop-
erly cabled and that you know how to install Windows NT Server Enterprise Edition.
Dell
®
PowerEdge
®
Cluster Installer Data Card and Checklist