Filter
Top Products
Index 3
PowerEdge Cluster
checking the functionality, 3-5
components, 1-1
getting started, 1-1
installation overview, 1-3
layout, 1-2
minimum system requirements, 1-2
PowerEdge RAID Console
rebuild operation, 3-9
using the maximize feature, 3-8
PowerEdge Scalable Disk System 100. See SDS 100
storage system
Print Spooler service, 4-3
Q
quorum resource
setting up, 3-8
R
rack configuration
Dell-supported, B-5
rack certification, B-2, B-6
safety notices, B-2
stability warnings, B-2, B-6
RAID controller
disabling the BIOS, 3-2
driver, 3-4
functionality, 3-8
location on PCI bus, 1-4, A-1
setting SCSI IDs, 3-2
verifying the driver, 3-6
RAID level
setting for internal hard-disk drives, 3-2
setting for shared storage subsystem, 3-2
rebuild
incomplete, 3-8
operation in RAID Console, 3-9
rate, 3-8
rediscovery application, 4-4
registry size, 3-5
return policy, G-2
S
safety
information for technicians, F-1
notices, B-2
preventing electrostatic discharge, vi
SCSI
disconnecting cables, 2-7
SCSI ID
setting, 3-2
verifying, 3-6
SDS 100 storage system
cabling, 2-1, 2-3, 2-4
upgrading the firmware, A-3
verifying operation, 3-5
shared storage subsystem
assigning drive letters, 3-4
setting the RAID level, 3-2
verifying drive letters, 3-6
small computer system interface. See SCSI
SMB
cabling, 2-5
stand-alone configurations
containing one SDS 100 storage system, B-3
containing two SDS 100 storage systems, B-4
Dell-supported, B-2
system configuration utility
updating for clustering, A-3
system management bus. See SMB
system requirements, 1-2