Filter
Top Products
If you cannot resolve the resource conflict by any
of the preceding methods, remove the new card.
If you were modifying an existing card, reset the
modified card to its previous resource value.
The configuration (.cfg) file used
by the ICU for this card is now
invalid or does not exist. Do you
wish to load the file?
No configuration (.cfg) file exists
for the card being modified. Do
you want to load one?
This message appears when
you try to add a listed card and
the configuration file for this
card has been corrupted or
deleted from the database.
This message appears when
you modify a card and its
configuration file does not exist
or has been deleted.
You can get a copy of the configuration file from the
original ISA Configuration Utility Diskette that you used
to create the backup ICU diskette. Use the following
procedure:
1. Insert the original ISA Configuration Utility
Diskette into drive A.
2. Change to the db subdirectory on the diskette
drive.
3. Use a text editor to search the icu.ndx file for the
card ID of the card you want to add or modify.
The name of the configuration file is part of this
card ID. For example, if the card ID is ICU0200,
the configuration file is !icu0200.cfg.
4. Copy the configuration file from the original ICU
diskette to the backup diskette.
This is an EISA system. Use an
ECU, not the ICU, to configure
your system.
This message appears if you
attempt to run the ICU on an
EISA system.
To use the ICU, you must load the utility onto a non-
EISA system.
You have added a card using
settings different from factory
default. Reconfigure the card to
the settings in the next
display (see the card's manual)
before installing it.
This message can appear in
two situations:
You added an ISA
expansion card, selected
OK, and the ICU had to
use resource values
different from the card's
defaults to avoid
conflicts.
You added an ISA
expansion card, selected
Advanced, and chose
resource values different
from the card's defaults.
Make a note of the new card configuration shown in the
Card Resource Usage dialog box displayed after this
message. Change jumper settings on the ISA expansion
card to match the new card configuration.
NOTE:For the full name of an abbreviation or acronym used in this table, see the "Glossary
".
Configuration Manager Messages
The Configuration Manager for the ICU identifies problems following the system boot routine and generates messages if necessary.
These messages alert you to any unsuccessful attempts to configure Plug and Play or Peripheral Component Interconnect (PCI)
expansion cards, as well as any problems that interfere with the operation of the Configuration Manager. If you receive a message
from the Configuration Manager, see Table C-2 for suggestions on resolving any problems indicated by the message.
Table C-2. Configuration Manager Messages