Filter
Top Products
Figure 17. Removing and Installing a Hard Drive/SSD
1. release button 2. hard drive/SSD
3. hard-drive/SSD connector (on backplane) 4. hard-drive/SSD carrier handle
Installing A Hard Drive/SSD
CAUTION: When a replacement hot-swappable hard drive/SSD is installed and the blade is powered on, the drive
automatically begins to rebuild. Make absolutely sure that the replacement hard drive/SSD is blank or contains
data that you wish to have over-written. Any data on the replacement hard drive/SSD is immediately lost after the
drive is installed.
NOTE: Not all operating systems support hot-swappable drive installation. See the documentation supplied with
your operating system.
1. Open the hard-drive/SSD carrier handle.
2. Insert the hard-drive/SSD carrier into the drive bay. Carefully align the channel on the hard-drive/SSD carrier with
the appropriate drive slot on the blade.
3. Push the drive carrier into the slot until the handle makes contact with the blade.
4. Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks into place.
The status LED indicator displays a steady green light if the drive is installed correctly. The drive carrier LED green
indicator flashes as the drive rebuilds.
Shutdown procedure for servicing a hard drive/SSD
NOTE: This section applies only to situations where the blade must be powered down to service a hard drive/SSD.
In many situations, the hard drive/SSD can be serviced while the blade is powered on.
CAUTION: If you need to power off the blade to service a hard drive/SSD, wait 30 seconds after the blade’s power
indicator turns off before removing the hard drive/SSD. Otherwise, the hard drive/SSD may not be recognized after
it is reinstalled and the blade is powered on again.
49