Filter
Top Products
Configuring Switching Information 405
The VLAN Querier page contains the following fields:
•
VLAN ID
— Specifies the VLAN for the IGMP Snooping Querier configuration.
•
VLAN Mode
— Enables or disables the IGMP Snooping Querier on the VLAN selected in the VLAN
ID field.
•
Querier Election Participate Mode
— Enables or disables the IGMP participation in election mode by
the Snooping Querier. When this mode is disabled, upon seeing another querier of same version in the
VLAN, the Snooping Querier transitions to non-querier state. When this mode is enabled, the
Snooping Querier participates in querier election, where in the lowest IP address wins the querier
election and operates as the querier in that VLAN. The other querier transitions to non-querier state.
•
Snooping Querier VLAN Address
— Specifies the Snooping Querier address to be used as source
address in periodic IGMP queries sent on the specified VLAN.
Adding a New VLAN and Configuring its VLAN Querier Settings
1.
Open the
VLAN Querier
page.
2.
Click
Add
.
The page refreshes, and the
Add VLAN
page displays.
Figure 7-81. Add VLAN Querier
3.
Enter the VLAN ID and, if desired, an optional VLAN name.
4.
Complete the fields on the page as needed.
5.
Click
Apply Changes
.
The VLAN Querier settings are modified, and the device is updated.
Displaying the VLAN Querier Summary Table
1.
Open the
VLAN Querier
page.
2.
Click
Show All
.
The
VLAN Querier Summary Table
displays.