Filter
Top Products
Configuring IP Multicast 765
Figure 12-31. Interface Membership Information
The Interface Membership Information page contains the following fields:
•
Interface
— Displays the interface on which MLD proxy is enabled.
•
Multicast Group IP
— Select the IP multicast group address for which data is to be displayed. If no
group membership reports have been received on the selected interface you will not be able to make
this selection, and none of the non-configurable data will be displayed.
•
Last Reporter
— The IP address of the source of the last membership report received for the IP
Multicast group address on the MLD Proxy interface.
•
Uptime
— The time elapsed since this entry was created. Displayed in hours:minutes:seconds.
•
State
— The state of the host entry. A host can be in one of the following states:
–
Non-member
. Does not belong to the group on the interface.
–
Delaying Member
. Host belongs to the group on the interface and report timer is running. The
report timer is used to send out the reports.
–
Idle Member
. Host belongs to the group on the interface and no report timer is running.
•
Filter Mode
— The group filter mode for the specified group on the MLD Proxy interface. Possible
values are
Include
,
Exclude
, or
None
.
•
Number of Sources
— The number of source hosts present in the selected multicast group.
Click Refresh to refresh the data on the screen with the present state of the data in the router.
Displaying IPv6 MLD Membership Information Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.