Filter
Top Products
Configuring IP Multicast 779
Figure 12-42. Add SSM Range
3.
Click the Add Default SSM Range check box to add the default SSM Range. The default SSM Range
is ff3x::/32.
4.
Enter the
SSM Group IP Address.
5.
Enter the SSM Group Mask (IPv4) or SSM Prefix Length (IPv6).
6.
Click
Apply Changes
.
The new SSM Range is added, and the device is updated.
Configuring the SSM Range Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM Commands
The following table summarizes the equivalent CLI commands for this feature.
BSR Candidate Configuration
Use this page to configure information to be used if the interface is selected as a bootstrap router.
To display the page, click IPv4 Multicast
→
PIM
→
BSR Candidate Configuration or IPv6 Multicast
→
PIM
→
BSR Candidate Configuration.
Table 12-38. PIM SSM Range Configuration Command
CLI Command Description
ipv6 pimsm ssm Defines the Source Specific Multicast (SSM) range of multicast
addresses.