Filter
Top Products
Menu Item Description
Remote Terminal
Type
Allows you to set the remote console terminal type. By default, the Remote
Terminal Type option is set to VT 100/VT 220.
Redirection After
Boot
Allows you to enable or disable to the BIOS console redirection when the
operating system is loaded. By default, the Redirection After Boot option is set to
Enabled.
System Profile Settings Screen
Menu Item Description
System Profile Allows you to set the system profile. If you set the System Profile option to a mode
other than Custom, the BIOS automatically sets the rest of the options. You can
only change the rest of the options if the mode is set to Custom. By default, the
System Profile option is set to Performance Per Watt Optimized (OS).
NOTE: The following parameters are available only when the System Profile is
set to Custom.
CPU Power
Management
Allows you to set the CPU power management. By default, the CPU Power
Management option is set to System OS DBPM. DBPM is Demand-Based Power
Management.
Memory
Frequency
Allows you to set the memory frequency. By default, the Memory Frequency
option is set to Maximum Performance.
Turbo Boost Allows you to enable or disable the processor to operate in turbo boost mode. By
default, the Turbo Boost option is set to Enabled.
C1E Allows you to enable or disable the processor to switch to a minimum
performance state when it is idle. By default, the C1E option is set to Enabled.
C States Allows you to enable or disable the processor to operate in all available power
states. By default, the C States option is set to Enabled.
Memory Refresh
Rate
Allows you to set the memory refresh rate. By default, the Memory Refresh Rate
option is set to 1x.
System Security Screen
Menu Item Description
Intel(R) AES-NI The Intel(R) AES-NI option improves the speed of applications by performing
encryption and decryption using the Advanced Encryption Standard Instruction Set
and is set to Enabled by default.
System Password Allows you to set the system password. This option is read-only if the password
jumper is not installed in the system.
Setup Password Allows you to set the setup password. This option is read-only if the password
jumper is not installed in the system.
Password Status Allows you to lock the system password. By default, the Password Status option is
set to Unlocked.
19