Filter
Top Products
1. Insert the hard drive into the hard-drive carrier with the connector end of the hard drive toward the
back.
2. Align the screw holes on the hard drive with the back set of holes on the hard-drive carrier.
When aligned correctly, the back of the hard drive will be flush with the back of the hard-drive
carrier.
3. Install the screws to secure the hard drive to the hard-drive carrier.
NOTE: When installing new hard drives into blank hard-drive carriers, use the spare hard-drive
screws supplied with the system.
Figure 18. Location of the Spare Hard-Drive Screws
1. spare hard-drive screw (16)
Cooling Fans
Your system supports up to six cooling fans.
NOTE: Hot-swap removal or installation of the fans is not supported.
NOTE: In the event of a problem with a particular fan, the fan number is referenced by the system’s
management software, allowing you to easily identify and replace the proper fan by noting the fan
numbers on the cooling fan assembly.
51