Filter
Top Products
The following items are in this menu:
v Drive Interface - use this to assign a SCSI ID to a SCSI drive or to assign a Port
Speed, Port Type, and Loop ID to a Fibre Channel drive. SAS drives do not
require user configuration. For more information on drive interfaces, refer to
“Host Interfaces” on page 3-6.
v Control Paths - use this to enable the drive as a control path drive. Each logical
library must have a control path drive; however, all drives in a logical library
can be designated as control path drives.
Configure: Network
Use these menu items to change the current network settings which allow you to
access the library remotely via a web browser.
v IP Stack - Choose IPv4 only, IPv6 only, or IPv4 & IPv6.
v IPv6 Only and Dual Stack IPv4 & IPv6 - Choose Enable Stateless Auto Config
Address (Web User Interface) or Stateless Autoconfig (Operator Control Panel) if
router assigned IPv6 IP addresses are desired. To view the router assigned IPv6
addresses after enabling Stateless Auto Config Address, do the following:
– Operator Control Panel (IPv6 Only): Monitor → Library → Network
Netmask
Gateway
IP Address
Configure
DHCP-OFF
Network
a77ug043
DHCP-ON
IP Stack
IP Address
DHCP-OFF
Ethernet
Figure 5-15. Configure: Network menu
Chapter 5. Operations 5-23