Filter
Top Products
Completing the Installation of the Replacement Library
Enclosure
1. Connect the following cables to the replacement library enclosure. (See
Figure 10-11 on page 10-11).
a. Power cord (6)
b. Host interface cable (1, 2, and/or 4)
c. Ethernet cable (5), if necessary
2.
Power ON the replacement library enclosure.
3. Upgrade library firmware and drive firmware to the latest version.
a. Visit http://www.support.dell.com/ to download the latest levels of library
and drive firmware.
b. Using the Web User Interface (Service Library → Upgrade Firmware),
upgrade library and drive firmware.
4. Run the Library Verify test (Operator Control Panel: Service → Library Verify).
This diagnostic requires a blank or scratch data cartridge.
5. Proceed to “Returning the Defective Library.”
Returning the Defective Library
1. Remove the shipping label (2 in Figure 10-15 on page 10-14) and lock (1)
from the rear panel of the defective library, place the lock in the slot located in
the top center of the library, and secure with the shipping lock label. This will
secure the library accessor for shipping.
2. Using the replacement library enclosure packaging materials, securely package
the defective library (including the left and right magazines, Library Controller
Card, and power supply removed from the replacement library enclosure) and
return it, to Dell.
Important: Failure to return all of these components to Dell will result in
you being charged for any missing components.
Chapter 10. Check, Adjust, Remove, and Replace 10-25