Filter
Top Products
Table 8-1. Error Codes
Error Code Description User Action
30 SCSI: transport element full
Check the application software.
31 SCSI: all slots empty
32 SCSI: invalid opcode
33 SCSI: invalid element address
34 SCSI: invalid field in CDB
35 SCSI: Invalid drive specified
36 SCSI: SEND DIAGNOSTIC command:
invalid test number
37 SCSI: invalid LUN
38 SCSI: parameter list length error
39 SCSI: parameter list error: invalid field
3A SCSI: parameter list error: parameter not
supported
3B SCSI: parameter value invalid
3C SCSI: saving parameters not supported
3D SCSI: invalid ID message
3E SCSI: destination element full
3F SCSI: source slot or drive empty
40 SCSI: wrong checksum
41 SCSI: command sequence error
42 SCSI: drive disabled
Check your configuration settings.
43 SCSI: mailslot disabled
44 SCSI: flash image does not fit bootcode
Check the application software.
45 SCSI: media removal prevented by drive
46 SCSI: media removal prevented by
library
47 SCSI: flash image does not fit personality Check the version of code used for the upgrade.
48 SCSI: drive type not supported in this
library
Check if a version of code is available which supports this
drive type.
49 SCSI: incompatible magazine, magazine
not accessible
Check your configuration settings.
4A SCSI: source not ready
Complete move process and retry operation.
4B SCSI: destination source not ready
4C SCSI: library controller busy Complete process and retry operation.
4D SCSI: cannot make reservation
Check application software.
4E SCSI: invalid slave robotic controller
request
4F SCSI: robotic axes/motors aren’t
initialized
Check robotics status.
8-2 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide