Filter
Top Products
3) Grasp the top and bottom edges of the power supply and pull it out of
the library.
b.
Install the power supply removed from the defective library in the
replacement library enclosure. Install the power supply removed from the
replacement library enclosure in the defective library to return to Dell. To
install a power supply:
1) Grasp two of the thumbscrews and push the power supply into the
library.
2) Tighten the thumbscrews.
3. Plug the power cord into the replacement library enclosure then into a power
source.
4. Power ON the replacement library enclosure.
a. If power ON is successful:
1) The replacement library enclosure will power up with the
Ready/Activity LED (1 in “Unpacking and Preparing the Replacement
Library Enclosure” on page 10-12) ON.
2) Power OFF the replacement library enclosure.
3) Unplug the power cord from the power source then from the library.
4) Proceed to “Installing the Replacement Library Enclosure.”
b.
If power ON is not successful, contact Technical Support for further
instructions.
Installing the Replacement Library Enclosure
Refer to the appropriate procedure in this section (rack or desktop) for installing
the replacement library enclosure.
Note: If you are shipping the replacement library enclosure to a remote location,
install the shipping lock and label before shipment.
a66mi096
Figure 10-23. A power supply being removed from a library
Chapter 10. Check, Adjust, Remove, and Replace 10-23