Filter
Top Products
a. DHCP Address - Click this item ON to have the IP Address of your library
automatically set by the library host computer. Leave unchecked and enter
the appropriate information for the IP Address, Network Mask, and
Gateway Address.
b. IP Address - An identifier for a computer or device on a TCP/IP network.
Networks using the TCP/IP protocol route messages based on the IP
address of the destination. The format of an IP address is a 32-bit numeric
address written as four numbers separated by periods. Each number can be
zero to 255. For example, 1.160.10.240 could be an IP address.
c. Network Mask - This address defines and limits users within a local
network.
d. Gateway Address - This address allows access outside the local network.
4. Enter IPv6 settings (if applicable).
a. DHCP Address - Click this item ON to have the IP Address of your library
automatically set by the library host computer. Leave unchecked and enter
the appropriate information for the IP Address, Network Mask, and
Gateway Address.
b. IPv6 stateless auto config - Stateless Auto config is ALWAYS on (not
defeatable). When logging in to the library on your browser using an IPv6
address, make sure you enclose the IPv6 address in square brackets. For
example: [0:0:0:0:0:0:0:0].
c. Static assigned IPv6 address - Enter the assigned IPv6 address. The format
of an IPv6 IP address is a 128-bit numeric address written as 8 groups of
four numbers separated by colons. When logging in to the library on your
browser using an IPv6 address, make sure you enclose the IPv6 address in
square brackets. For example: [0:0:0:0:0:0:0:0].
d. IPv6 prefix length - The default prefix length is set to 64, but can be set to
any length, depending upon the address used.
e. IPv6 gateway address - This address allows access outside the local
network.
5. Enter SNMP settings.
a. SNMP Enabled - If you desire to have SNMP Traps sent to an IP address of
your choosing, place a check in this box.
b. SNMP Target 1-IP Address - If SNMP Traps are enabled, enter an IP
address where SNMP Traps are to be sent.
c. SNMP Target 2-IP Address - Enter an optional 2nd IP address where SNMP
Traps are to be sent, or leave as 0.0.0.0.
d. SNMP Target 3-IP Address - Enter an optional 3rd IP address where SNMP
Traps are to be sent, or leave as 0.0.0.0.
e. Community Name - Enter your preferred name, or leave as “public”. The
Community Name is limited to 33 alpha-numeric characters (A-Z, a-z, 0-9).
6. Enable SSL for secure Web communication - If you desire to have SSL (Secure
Sockets Layer) enabled, place a check in this box.
7. Select an Ethernet Setting - You can disable Ethernet settings, manually enable
them, or let another machine enable them by using Dynamic Host
Configuration Protocol (DHCP). You can also set a specific speed for the
Ethernet port or specify the library to automatically negotiate the speed.
Ethernet Settings choices are: Auto (the default), 10 Mbit/Half, 10 Mbit/Full,
100 Mbit/Half, 100 Mbit/Full. Please refer to http://support.dell.com to
determine the availability of manual Ethernet settings in your library’s
firmware.
Chapter 4. Installation and Configuration 4-25