Filter
Top Products
Unpacking and Preparing the Replacement Library Enclosure
Before installing the replacement library enclosure, it is important to verify that the
enclosure is functioning properly.
1. Unpack the replacement library enclosure and place it on a sturdy and clean
work surface near the defective library. Save all packaging materials for
returning the failing part(s) to Dell.
2. Choose one of the options below for installing the foot pads.
Important: Operating your library on a flat surface without foot pads may
damage your library or cause it not to function properly.
a. For a rack mounted library:
1) Lift the replacement library enclosure slightly above the work surface,
have another person place a foot pad under each corner of the library
and on each side of the library halfway between the front and back.
2) Gently set the replacement library enclosure on top of the feet. Adjust
foot pad placement as necessary to stabilize the library. It is not
necessary to permanently attach the foot pads to the library.
b.
For a desktop library:
1) Carefully, lay the library on its side.
2) Peel the adhesive from the back of each of the six foot pads.
3) Install the foot pads on the bottom of the library enclosure by pressing
each foot into one of the six areas (1) as shown in Figure 10-13 on
page 10-13.
10-12 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide