Denso BHT-6000 Scanner User Manual


 
125
Chapter 4. Error Messages
Execution program not selected
Problem
No user program has been selected as an execu-
tion program to be run when the power is turned
on.
Solution
Operate the BHT-6000 in System Mode and select
an execution program in the SET SYSTEM menu.
(For the selecting procedure, refer to Chapter 2,
Subsection 2.5.3, [4.1].)
No execution
program selected
Contact your
administrator.
Resume data saving error
Problem
When the power was turned off, the system failed
to save resume data although the resume function
had been set to ON.
The BHT-6000 displays this error message
for two seconds and automatically runs the
execution program from the point of start-up.
NOTE
Resume failure !
Program restarts
automatically.