Denso BHT-6000 Scanner User Manual


 
53
Chapter 2. Getting Started the BHT-6000 and System Mode
(3) Character length screen
(4) Stop bit length screen
SET DATA BIT
< CONNECTOR >
1:7 bits
2:8 bits
Selecting "3:DATA BIT" on the SET CONNECTOR
screen calls up the screen shown at left.
Select the desired character length by using the
numerical keys or F5 and F6 keys, and then
press the ENT key.
To return to the SET CONNECTOR screen, press
the C key.
Selecting "4:STOP BIT" on the SET CONNECTOR
screen calls up the screen shown at left.
Select the desired stop bit length by using the
numerical keys or F5 and F6 keys, and then
press the ENT key.
To return to the SET CONNECTOR screen, press
the C key.
SET STOP BIT
< CONNECTOR >
1:1 bit
2:2 bits
(5) Communications protocol option menu
SET PROTOCOL
< CONNECTOR >
1:SERIAL No.
2:H.PARITY
3:LINKUP TIME
4:FIELD SPACE
Selecting "5:PROTOCOL" on the SET CONNECTOR
screen calls up the screen shown at left.
1 SERIAL No.: Switches to the serial number
ON/OFF screen.
2 H. PARITY: Switches to the horizontal
parity ON/OFF screen.
3 LINKUP TIME: Switches to the timeout
length screen.
4 FIELD SPACE: Switches to the space code
handling screen.
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET CONNECTOR screen, press
the C key.
If the BHT-Ir protocol has been selected, the
serial number and horizontal parity settings
will be ignored.
NOTE