Filter
Top Products
27
Dialogic
®
SS7G21 and SS7G22 Signaling Servers Hardware Manual Issue 7
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by the ACTA.
The T1 interface provided on this equipment is classified by the FCC as an “XD” terminal device (T1 DSX-1
type) and must be connected behind a registered CSU or PBX.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of the service may be required. But if advance notice isn't practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file
a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make necessary modifications to maintain uninterrupted service.
To return a board for warranty repair or any other returns, please contact your Dialogic vendor from whom
you purchased the board or Dialogic Technical Services and Support (see http://www.dialogic.com/support/
contact/ for contact information). If the equipment is causing harm to the telephone network, the telephone
company may request that you disconnect the equipment until the problem is resolved.
Telephone companies report that electrical surges, typically lightning transients, are very destructive to
customer terminal equipment connected to AC power sources. The use of a surge arrestor on the AC line is
recommended.
It is not intended that any component devices shall be added into this equipment, except for those bearing
the same ACTA product-labeling number as that shown on the product label. To do so may invalidate the
existing registration, and you would become responsible for Part 68 compliance evaluation, and registration
of the resulting equipment.
4.2.4 Telecommunications Attachment Notice - Canada
This product meets the applicable Industry Canada technical specifications.
The IC registered number that features on the product label, relates to the included board(s) that provide
the T1 interface of the product.
It is not intended that any component devices shall be added into this equipment, except for those bearing
the same IC registered number as that shown on the product label. To do so may invalidate the existing
registration, and you would become responsible for compliance evaluation, and registration of the resulting
equipment.
4.2.5 ICES-003 Electromagnetic Compatibility Notice - Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
4.2.6 Telecommunications Notice - Australia / New Zealand
The primary role of this product is as Telecommunications Network Equipment. The product is not considered
to be Customer Equipment (CE). It is the responsibility of the system integrator or network operator to
ensure that installations meet Telecommunication specifications in support of interconnect agreements.
4.2.7 Telecommunications Notice - Taiwan
When deploying this product for use in Taiwan, the telecommunications interfaces can only be configured for
E1 operation.