xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 6 - 19. Add Access Rule window for IPv6 example
The following parameters may be configured for IPv6:
Parameter Description
Access ID (1-65535)
Type in a unique identifier number for this access. This value can be set from 1 to 65535.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an
Access ID for the rule being created.
Class
Entering a class will instruct the Switch to examine the class field of the IPv6 header. This
class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Flow Label
Specifies the IPv6 Flow Label. Enter a value between 0 – FFFFF.
IPv6 Source Address
Specifies an IPv6 address for the IPv6 source address.
IPv6 Source Mask
Specifies an IPv6 source submask. The device only supports filtering of the last 44 bits
(LSB) of the source IPv6 address.
TCP
Source Port - Specifies an IPv6 L4 TCP source port submask.
Destination Port - Specifies an IPv6 L4 TCP destination port submask.
UDP
Source Port - Specifies an IPv6 L4 UDP source port submask.
Destination Port - Specifies an IPv6 L4 UDP destination port submask.
Action
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Priority (0-7)
Enter a priority value if you want to re-write the 802.1p default priority of a packet to the
value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
162