D-Link 28 Switch User Manual


 
xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Telnet Settings
Telnet configuration is Enabled by default. If you do not want to allow configuration of the system through Telnet
choose Disabled. The TCP ports are numbered between 1 and 65535. The "well-known" TCP port for the Telnet
protocol is 23.
To access this window, click Configuration > Telnet Settings:
Figure 2 - 22. Telnet Settings window
Password Encryption
Password Encryption can be Enabled or Disabled in this window. It is Disabled by default. Password encryption allows
the user to encrypt a password for additional security. Select Enabled to change the password into encrypted form.
When password encryption is Disabled, the password will be in plain text form. However, if the user specifies the
password in encrypted form, or if the password has been converted to encrypted form by the last enable password
encryption command, the password will still be in encrypted form and cannot be reverted back to plain text form.
To access this window, click Configuration > Password Encryption:
Figure 2 - 23. Password Encryption window
CLI Paging Settings
CLI paging can be Enabled or Disabled in this window. It is Enabled by default. CLI paging settings are used when
issuing a command which causes the console screen to rapidly scroll through several pages. This command will cause
the console to pause at the end of each page.
To access this window, click Configuration > CLI Paging Settings:
Figure 2 - 24. CLI Paging Settings window
30