Filter
Top Products
DES-3550 Fast Ethernet Layer 2 Switch
View Name
Type an alphanumeric string of up to 32 characters that is used to identify the group
of MIB objects that a remote SNMP manager is allowed to access on the Switch. The
view name must exist in the SNMP View Table.
Access Right
Read Only - Specifies that SNMP community members using the community string
created can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string
created can read from, and write to the contents of the MIBs on the Switch.
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the under
the Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Security Management folder and click on the SNMP Host Table link.
This will open the SNMP Host Table page, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host
IP Address heading.
Figure 7- 35. SNMP Host Table
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page.
This will open the SNMP Host Table Configuration page, as shown below.
Figure 7- 36. SNMP Host Table Configuration
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
140