Filter
Top Products
DXS/DWS 3200 Series User Guide
Page 20
Cable, Port, and Pinout Information
This section describes the devices physical interfaces and provides information about cable connections. Stations
are connected to the device ports through the physical interface ports on the front panel. For each station, the
appropriate mode (Half/Full Duplex, Auto Negotiation) is set. The default is Auto Negotiation.
Pin Connections for the 10/100/1000 Ethernet Interface
The switching port can connect to stations wired in standard RJ-45 Ethernet station mode using straight cables.
Transmission devices connected to each other use crossed cables. The following figure illustrates the pin alloca-
tion.
Figure 15: RJ-45 Pin Allocation
The following table describes the pin allocation:
Amber An error is occurred at this port
Off There is no error at this port
alternating Green
and Amber
An error is occurred at this port
Table 5: RJ-45 Pin Connections for 10/100/1000 Base-TX
Pin Use
1
TxRx 1+
2
TxRx 1-
3
TxRx 2+
4
TxRx 2-
5
TxRx 3+
6
TxRx 3-
7
TxRx 4+
8 TxRx 4-
Table 4: System’s LED Indications
LED Description LED
Indication
Description