Filter
Top Products
Managing Device Diagnostics
Viewing Optical Transceivers
Page 279
Viewing Optical Transceivers
The Optical Transceiver page allows network managers to perform tests on Fiber Optic cables. Optical transceiver
diagnostics can be performed only when the link is present. To test cables:
• Click System > Diagnostics > Optical Transceivers tab. The Optical Transceivers Page opens:
Figure 186: Optical Transceivers Page
The Optical Transceivers Page contains the field:
• Port — Displays the port IP address on which the cable is tested.
• Temperature — Displays the temperature (C) at which the cable is operating.
• Voltage — Displays the voltage at which the cable is operating.
• Current — Displays the current at which the cable is operating.
• Output Power — Indicates the rate at which the output power is transmitted.
• Input Power — Indicates the rate at which the input power is transmitted.
• Loss of Signal — Indicates if a signal loss occurred in the cable.
Note
This page is dependent on the optical transceiver. If the information is not provided or supported by the
transceiver, the switch would not be able to provide such information.