Draytek 2750 Network Router User Manual


 
Vigor2750 Series User’s Guide
216
When TSPC configuration has been done, the router will start to connect. The connecting page
will be shown as below:
When the router detects all the information, the screen will be shown as follows. One set of
TSPC prefix and prefix length will be obtained after the connection between TSPC and
Tunnel broker built.
Connection Status It will bring out different pages to represent IPv6
disconnection, connecting and connected.
Tunnel Information Display interface name (used to send TSPC prefix), tunnel
mode, local endpoint addresses, remote endpoint address,
TSPC Prfix, TSPC Prefixlen (prefix length), tunnel broker
and so on.
Tunnel Status Disconnected - The remote client doesn't connect to the
tunnel server.
Connecting - The remote client is connecting to the tunnel
server.
Connected – The remote client has been connected to the
tunnel server.
Activity Sent - sent to the tunnel (RX bytes).
Received - received from the tunnel (RX bytes).