Filter
Top Products
Ch
apter
3
:
C
on
fi
gurat
i
on
7
Chapter 3
Configuration
In order to access the Internet through the router, each host on your network must install/setup
TCP/IP. Please follow the steps below for select a network adapter.
Setting TCP/IP on Client PC
To access the ADSL Router via Ethernet, the host computer must meet the following requirements:
With Ethernet network interface.
Must have TCP/IP installed.
Set client PC with obtain an IP address automatically or set fix IP address.
With a web browser installed: Internet Explorer 5.x or later.
The ADSL Router is configured with the default IP address of 192.168.1.1 and subnet
mask of 255.255.255.0. As the DHCP server is Enable by default, The DHCP clients should
be able to access the ADSL Router. Or you could assign an IP address to the host PC first for initial
configuration.
You also can manage the ADSL Router through a web browser-based manager: ADSL ROUTER
CONTROL PANEL. The ADSL Router manager uses the HTTP protocol via a web browser to allow
you to set up and manage the device.
To configure the device via web browser, at least one properly-configured PC must be connected to
the network (either connected directly or through an external hub/switch to the LAN port of the
device).
If TCP/IP is not already installed, follow the steps below for installation.