Filter
Top Products
AD
S
L Router User Manua
l
40
Adding a New One
To add a new WAN connection, please click the Add button. The following screen appears.
VPI (Virtual Path Identifier):
Identifies the virtual path between endpoints
in an ATM network. The valid range is from
0 to 255.
VCI (Virtual Channel Identifier):
Identifies the virtual channel endpoints in an
ATM network. The valid range is from 32 to
65535 (1 to 31 is reserved for well-known
protocols).
Service Category:
There are five categories provided here for
your selection. Please choose any one of it as
you desired.
If you choose Non Realtime VBR, you have
to type in the following data.
The range for Peak Cell Rate is from 1 to
1690.
The range for Sustainable Cell Rate is from
1 to 1689 and must be smaller than Peak Cell
Rate.
The range for Maximum Burst Size is from 1
to 100.
You have to type in the VPI and VCI values in the entry boxes. Then click Next. The screen will get
into the Connection Type page of Quick Setup and ask you to fill in the data according to the request
of the screen. Refer to Quick Setup for more information if you don’t know how to set the
configuration.
WAN - ADSL Settings
Modulation:
There are five selections for your choosing.
Select the one that you need.
IP Routing - Static Route
Routing Table shows all static route status and allows you to add new static IP route or delete IP route.
A Static IP Routing is a manually defined path, which determines the data transmitting route. If your
local network is composed of multiple subnets, you may want to specify a routing path to the routing
table.