Filter
Top Products
49
Using Effects
(continued)
Input/output
settings
Introduction Connections Basic operation Switching images Effects BPM sync External devices Video fader Appendices
You can add color according to the brightness or darkness of the image, making the image more colorful.
1
Set the [MEMORY] knob to memory number 1.
* The factory preset settings are assigned to memory number 1. For details on
the [MEMORY] knob, refer to “Storing the Operating Panel Settings” (p. 28).
2
Press a bus A INPUT SELECT button to select an image.
3
Move the video fader to the bus A position to output the bus A image.
4
Press the bus A EFFECTS [3 (COLORIZE)] button to turn on the Colorize effect.
The [3 (COLORIZE)] button will blink, and the Colorize effect will be applied to
the bus A output image.
5
Operate the bus A [CONTROL] fader to change the colorization pattern.
* The blinking of the [3 (COLORIZE)] button indicates that you can use the
[CONTROL] fader to change colorization patterns (eight types).
6
Press the [3 (COLORIZE)] button once again to turn off the Colorize effect.
The [3 (COLORIZE)] button will go out.
Adding Color According to the Brightness or Darkness of the Image (Colorize)
• For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to “Effects that Cannot Be Used Simultaneously” (p. 107).
• You can change the effect that is assigned to the [3 (COLORIZE)] button. For details, refer to “Assigning Different Effects
to the EFFECTS Buttons” (p. 53).
V-8_e.book 49 ページ ２００８年５月１５日 木曜日 午後１時１１分