Filter
Top Products
Using Effects
(continued)
52
You can invert the image between top/bottom, left/right, or top/bottom/left/right.
1
Set the [MEMORY] knob to memory number 1.
* The factory preset settings are assigned to memory number 1. For details on
the [MEMORY] knob, refer to “Storing the Operating Panel Settings” (p. 28).
2
Press a bus B INPUT SELECT button to select an image.
3
Move the video fader to the bus B position to output the bus B image.
4
Press the bus B EFFECTS [1 (FLIP)] button to turn the Flip effect on.
The [1 (FLIP)] button will blink, and the bus B output image will be flipped.
5
Operate the bus B [CONTROL] fader to change the direction of the flip.
* The blinking of the [1 (FLIP)] button indicates that you can use the
[CONTROL] fader to switch between different directions (three choices) for the
Flip effect.
6
Press the [1 (FLIP)] button once again to turn off the Flip effect.
The [1 (FLIP)] button will go out.
Inverting the Image (Flip)
• For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to “Effects that Cannot Be Used Simultaneously” (p. 107).
• You can change the direction in which the image is flipped, and the effect that is assigned to the [1 (FLIP)] button. For
details, refer to “Assigning Different Effects to the EFFECTS Buttons” (p. 53).
V-8_e.book 52 ページ ２００８年５月１５日 木曜日 午後１時１１分