Filter
Top Products
51
Using Effects
(continued)
Input/output
settings
Introduction Connections Basic operation Switching images Effects BPM sync External devices Video fader Appendices
You can divide the screen horizontally and vertically to display the input image.
1
Set the [MEMORY] knob to memory number 1.
* The factory preset settings are assigned to memory number 1. For details on
the [MEMORY] knob, refer to “Storing the Operating Panel Settings” (p. 28).
2
Press a bus A INPUT SELECT button to select an image.
3
Move the video fader to the bus A position to output the bus A image.
4
Press the bus A EFFECTS [4 (MULTI)] button to turn on the Multi-screen effect.
The [4 (MULTI)] button will blink, and the multi-screen effect will be applied to the
bus A output image.
5
Operate the bus A [CONTROL] fader to change the dividing pattern for the screen.
* The blinking of the [4 (MULTI)] button indicates that you can use the
[CONTROL] fader to switch between dividing patterns (seven types).
6
Press the [4 (MULTI)] button once again to turn off the Multi-screen effect.
The [4 (MULTI)] button will go out.
Using Multi-Screen
• For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to “Effects that Cannot Be Used Simultaneously” (p. 107).
• You can change the direction in which the screen is divided, and the effect that is assigned to the [4 (MULTI)] button. For
details, refer to “Assigning Different Effects to the EFFECTS Buttons” (p. 53).
V-8_e.book 51 ページ ２００８年５月１５日 木曜日 午後１時１１分