Filter
Top Products
HARSFEN0602
mechanical revolution.
CA[23] For linear motors, CA[23] stores the number of counts per user unit (Meter, or
any other unit the user may select). CA[23] is stored only for convenience – the
Harmonica software does not use this number for any internal calculation.
For rotary motors, set CA[23]=0.
YA[1],YA[3] YA[1] is the auxiliary feedback resolution, counts/physical unit. YA[3] sets
what a physical unit is: Revolution, Meter, or other.
YA[1] and YA[3] are stored only for convenience – the Harmonica software
does not use these numbers for any internal calculation.
2.4.2 Speed and acceleration units
The speed units are counts/sec, and the acceleration units are counts/sec
2
. The speed units
may be related to physical units by converting the counts to revolutions, Meters, etc, as
explained in the section "Position units" above.
2.4.3 Current and torque
Currents are measured in Amperes. That is not so simple as it sounds, since there is no
single accepted method to specify the current of three-phased motors.
For sinusoidal motors, RMS phase current normally specifies the motor current. The RMS is
taken over a mechanical revolution; so that the phase currents are the "Motor current" only if
the motor revolves with constant speed.
For trapeze-wound motors, the conventional six-steps drive leaves one motor phase open
circuited, and only one current flows through the two driven motor phases. This driven
phases current specifies the "Motor current". For trapeze-wound motor running six-step
commutation continuously at 1Amp, the RMS current is 0.92Amp.
The Harmonica has one motor current definition, although it can run equally well sinusoidal,
Trapezoidal, or free form motor windings.
We defined the motor current as the maximum winding current in a mechanical revolution.
This definition is consistent with the traditional current definition for six-step motors and it
readily extend to other winding forms.
The user of sinusoidal motors must multiply the motor current reported by the Harmonica by
the factor of 0.71 to obtain the RMS phase current.
2.5 Internal Units and Conversions
In order to optimize the use of its CPU, the Harmonica works inside with local units for
time, for current, for DC bus voltage, and for electrical angle.
The user normally thinks of time in terms of seconds. Most of the control algorithms view time
by counting controller sampling-times.
The user thinks of currents in terms of Amperes. The Harmonica thinks internally in the terms of
A/D bits.
The user may think of electrical angles in terms of degrees or radians. The Harmonica divides
the electrical cycle to 1024.
Normally the internal representation of time and currents is transparent to the user. For
example, the user demands motor current in Amperes, and accepts motor current reports in
Amperes as well. The Harmonica does the translation. The following situations, however,
require the user to consider the internal data representation.
Uploading data from the real time recorder - Refer "The Recorder" Chapter.
Interpreting CAN mapped synchronous PDO's
Specifying motions in the micro stepping mode.
Some user interface commands retrieve the conversion factors for user convenience.
2.5.1 Current and torque: