Filter
Top Products
10002367-02 PmT1 and PmE1 User’s Manual
2-1
Section 2
Setup
This chapter describes the physical layout of the boards, the setup process, and how to
check for proper operation once the boards have been installed. This chapter also includes
troubleshooting, service, and warranty information.
ELECTROSTATIC DISCHARGE
Before you begin the setup process, please remember that electrostatic discharge (ESD) can
easily damage the components on the PmT1 and PmE1 hardware. Electronic devices, espe-
cially those with programmable parts, are susceptible to ESD, which can result in opera-
tional failure. Unless you ground yourself properly, static charges can accumulate in your
body and cause ESD damage when you touch the board.
Caution: Use proper static protection and handle the PmT1 and PmE1 board only when absolutely
necessary. Always wear a wriststrap to ground your body before touching a board. Keep
your body grounded while handling the board. Hold the board by its edges–do not touch
any components or circuits. When the board is not in an enclosure, store it in a static-
shielding bag.
To ground yourself, wear a grounding wriststrap. Simply placing the board on top of a static-
shielding bag does not provide any protection–place it on a grounded dissipative mat. Do
not place the board on metal or other conductive surfaces.
PMT1 AND PME1 CIRCUIT BOARD
The PmT1 and PmE1 circuit board is a PMC module assembly. It uses an eight-layer printed
circuit board with the following dimensions:
Table 2-1: Circuit Board Dimensions
The following figures show the front panel and component maps for the PmT1 and PmE1
circuit board.
Figure 2-1: PmT1 and PmE1 Front Panel
Width: Depth: Height:
5.86 in. (148.8 mm) 2.913 in. (74.0 mm) .39 in. (10.0 mm)
!
TDM B
TDM A