Filter
Top Products
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
Safety Notes
20
Emerson Network Power Embedded Computing (ENPEC) and our suppliers take significant
steps to ensure there are no bent pins on the backplane or connector damage to the boards
prior to leaving the factory. Bent pins caused by improper installation or by inserting boards
with damaged connectors could void the ECC warranty for the backplane or boards.
Incorrect installation of the product can cause blade damage.
Only use handles for when installing/removing the product to avoid damage/deformation to
the face plate and/or PCB
Cabling and Connectors
Damage of the Product
The RJ-45 connector(s) on the face plate are either twisted-pair Ethernet (TPE) or E1/T1/J1
interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage the product.
z Make sure that TPE connectors near your working area are clearly marked as network
connectors.
z Verify that the length of an electric cable connected to a TPE bushing does not exceed 100
meters.
z Make sure the TPE bushing of the product is connected only to safety extra low voltage
circuits (SELV circuits).
If in doubt, ask your system administrator.
Laser
This product is a Class 1 laser product. The use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
Environment
Always dispose of used blades, system components and RTMs according to your country’s
legislation and manufacturer’s instructions.