Filter
Top Products
Installation of the RTM-ATCA-7150
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
51
7. Insert RTM-ATCA-7150 with the GE daughter card installed in the shelf. For more
information refer, Installing RTM-ATCA-7150.
After installation, check if RTM-ATCA-7150 can be powered on and work normally. Use the
network cable to connect RTM-ATCA-7150 to the external network. Check if the network is
connected properly and monitor whether the network port indicator is normal.
2.6.3.3 Replacing the GE Daughter Card
To replace the GE daughter card, proceed as follows.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap.
2. Remove the RTM-ATCA-7150 whose GE daughter card is to be replaced. For more
information refer, Removing RTM-ATCA-7150.
3. As shown in step 1 of the figure below, open the plastic latches fastening the GE
daughter card.
4. Exert even force upwards until the daughter card connector is removed from the
connector on RTM-ATCA-7150. As shown in step 2 of the figure below, remove the
daughter card by facing the daughter card at an angle of 45° to the RTM.
5. Place the removed GE daughter card in an antistatic package.