Filter
Top Products
Installation of the RTM-ATCA-7150
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
62
2.7.2 Removing RTM-ATCA-7150
To remove RTM-ATCA-7150, proceed as follows:
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap.
2. The OOS, blue, and the healthy LEDs of the RTM are on. Open the ejector handles
of the front blade to power it down.
3. As shown in step 2 of the figure below, use the screwdriver to unfasten the captive
screws of the RTM anticlockwise.
4. As shown in step 1 of the figure below, fully open the upper and lower ejector
handles.
Product Damage
You should power off the front blade before removing RTM-ATCA-7150.