Filter
Top Products
Hardware Installation of ATCA-7150
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
83
2. Lay the ATCA-7150 where the DIMM is to be installed on the antistatic desktop.
3. Take the DIMM out of the antistatic package.
4. Make sure that two interface fixing clips are fully open. Adjust the DIMM to align it with the
DIMM interface.
5. Insert the DIMM in the interface along the guide rails, as shown in Figure 3-4.
6. Make sure that the fixing clips are fastened or closed firmly as shown in Figure 3-4.
Product Damage
Operate the fixing clips slightly to avoid breaking them or damaging the DIMM interface.
If there is a gap between the DIMM and the fixing clips, the DIMM is not installed properly. In
this case, open the fixing clips and remove the DIMM. Then, insert the DIMM again.