Filter
Top Products
Add/Delete Entry Screen
Local Management 3-21
3.6 ADD/DELETE ENTRY SCREEN
The Add/Delete Entry screen is used to create, modify, or delete PVCs.
To access the Add/Delete Entry screen from the ATM Connection Setup screen perform the
following steps:
1. Use the arrow keys to highlight the ADD/DELETE command at the bottom of the ATM
Connection Setup screen.
2. Press ENTER, the Add/Delete Entry screen, Figure 3-8, displays.
Figure 3-8 Add/Delete Entry Screen
The following list explains each Add/Delete Entry screen field:
VPI (Modifiable)
Used to enter the Virtual Path Identifier of the PVC. The available range for this field is 0 or 1,
with a default value of 0.
VCI (Modifiable)
Used to enter the Virtual Channel Identifier of the PVC. The available range for this field is 32
through 1019.
NOTE: The Add/Delete Entry screen will display only if the host device has been set
to operate as a SecureFast switch with the VHSIM2-A6DP installed
. Refer to the Local
Management chapter of the host device for instructions on configuring the host device
for this type of operation.
RETURN
VPI VCI AAL Type Encapsulation Type
0 0 [ 5 ] [VC Mux 802.3 Bdg]
EXITADD/MODIFY
2825 13