Filter
Top Products
LEC Administration Screen
3-40 Local Management
•Join-During the Join phase, the LEC establishes a Control Direct VCC with the LES. After
this connection is made, the LEC is assigned a LEC ID, the name of the ELAN it will join, and is
notified of the maximum frame size allowed on the ELAN and the LAN type that is being
emulated (IEEE 802.3). The initialization process then proceeds to the Initial Registration phase.
• Initial Reg. - The Initial Registration phase is used by the LEC to confirm that its MAC
Address(es) is unique before becoming fully operational on the network. During this phase, the
LEC may also register any additional unicast LAN destinations and Route Descriptors.
• BUS Connect - While in the BUS Connect phase, the LEC connects to the Broadcast and
Unknown server (BUS). At the end of this phase, the LEC has a BUS Multicast Send VCC and a
BUS Multicast Forward VCC with the BUS. Once these VCCs have been created, the LEC
becomes operational on the network.
• Operational - The LEC is now fully configured, and is switching traffic.
3.13 LEC ADMINISTRATION SCREEN
The LEC Administration screen is used to add, modify and delete LAN Emulation Clients (LECs).
To access the LEC Administration screen from the ATM screen, perform the following steps:
1. Use the arrow keys to highlight the LEC ADMINISTRATION menu item from the LAN
Emulation Clients screen.
2. Press ENTER; the LEC Administration screen, Figure 3-15, displays.
Figure 3-15 LEC Administration Screen
RETURNADD LEC MODIFY MODE
LEC Index:
LEC Status:
LANE Version
Configure LEC:
ELAN Name:
MTU Size:
Selective Multicast:
LLC Multiplex Capable
Topology Change Frames:
2
[Active]
[2.0]
[Automatic]
_________
[1516]
[Disable]
[Disable]
[Disable]
EXIT
SCREEN IS IN CREATE MODE
This LEC does not exist yet.
Select ADD to create it.
All values correspond with
the lecConfigTable of the
ATM Forum LEC MIB
LES/LECS Address:
0x00.0000.00.000000.0000.0000.0000.000000000000.00
2825_20