Filter
Top Products
B-5
Error Code Problem Steps to take
xxxx: [yyyy]: “zzzz”: entry
is invalid
Entry zzzz in sec-
tion yyyy of file
xxxx contains an
invalid value.
• Check the entry in the
configuration for zzzz.
• If you cannot find zzzz in the
Ethernet Adapter Manager
program, you may have to use
the serial port or telnet
configuration menus. See
Appendix A for details.
Unable to bring up interface
“lanX”.
Configuration
values for the radio
may be incorrect.
Check the configuration for the
PCMCIA radio card used.
Xxxx: <[yyyy]zzzz>:
Unable to add route.
Route values are out
of range compared to
the interface values.
• Set the route value to
“automatic.”
• If “automatic” does not work
for your Ethernet Adapter,
check the values you set for
the route to make sure they
correspond to your other IP
parameters.
UART Error – No Rx Buffer
Available
Data is being sent to
the UART at a rate
faster than it can
clear its receive buff-
ers, and data is being
lost.
• Enable flow control for your
serial application.
• Note: If you are using the
serial port menu system for
configuration, flow control
will not be enabled in the
Ethernet Adapter. To avoid
getting this while in the serial
port configuration system,
type slower.
Any other errors
• If the event log instructs you
to contact Technical Support,
please do so now before
continuing.
• Reset the Ethernet Adapter.