Filter
Top Products
Network Serial Port
C-6
TCP Listen Port Configuration
Complete the configuration described in Network Serial Port Configuration, steps 1–4,
and then perform the following steps:
1) Click on TCP Listen Port in the Protocol list.
2) Click on the Listen tab.
3) Type in the port number on which the Ethernet Adapter will listen for a
connection. This is the port number that your program will use to connect to
that Ethernet Adapter. The default is 4000.
4) For most applications, leave the Reconnect After Shutdown box checked.
Checking this box causes the Ethernet Adapter to listen for and accept a new
connection if the active one closes.
5) Click on the Update and Reset Unit button.
TCP Connect Port
Complete the configuration described in Network Serial Port Configuration, steps 1–4,
and then perform the following steps:
1) Click on TCP Connect Port tab page.
2) In the Connect to IP field, enter the IP address of the device that the Ethernet
Adapter is connecting to.
3) In the Connect to Port field, type the port number to which the Ethernet
Adapter will connect. The default is 4000.
4) For most applications, leave the Reconnect After Shutdown box checked.
Checking this box causes the Ethernet Adapter to re-initiate a new connection
if the active one closes.
5) Click on the Update and Reset Unit button.