Filter
Top Products
Using the Default-Setting Mode
Skip-over-perforation
When this option is set to on, the printer skips over the perforations
of continuous paper, so that it provides a l-inch margin between the
last line printed on one page and the first line printed on the next.
Since most application programs insert their own top and bottom
margins, you should use this feature only if your program does not
provide them. This feature is active only if you install the optional
push tractor.
Tear-off position
When you use continuous paper with the optional push tractor, this
feature advances the paper so you can tear off the printed page and
then reverses the paper so you can use all of the next sheet. You can
choose from two tear-off positions with this printer.
If you select On cutter, the printer feeds the paper perforation to the
edge of the printer cover. If you select Above cutter, the printer
feeds the perforation about 80 mm (3 inches) beyond the printer
cover’s edge.
TOF (top-of-form) position
Whenever you press the
FORM FEED
button or send the form feed
command, the printer loads paper to the top-of-form (TOF) position.
The TOF position is factory set to the ±0 position (8.5 mm -
.33 inches - from the top edge of paper). You can set this position
from -3 to +3 in l-mm (.04 inches) increments.
Graphic print direction
Printing is normally bidirectional. However, unidirectional printing
allows for precise vertical alignment of print dots. If you select
unidirectional printing, the printer prints graphics unidirectionally
even if you select bidirectional with the ESC UO software command.
3-12
Using the Printer