Filter
Top Products
6. Open the paper bail using the tab on its right side. Then tilt
the pull tractor back until its rear latches click into place
over the printer’s rear mounting pins.
7. Gently close the paper bail (do not apply excess pressure),
and then close the printer’s top cover.
Using the pull tractor with the front tractor
If you are using labels or multi-part forms with more than six
parts (including the original), you should use the pull tractor
with the printer’s built-in front tractor.
You can switch between the front and rear tractors at any time
when you are using the pull tractor. Just press the Front/Rear
button and then use the LF/FF Load button to feed the paper
the additional distance to the pull tractor. (Labels require
special handling. See “Using labels” in Chapter 3.)
To tear off documents, press the LF/FF Load button to advance
the paper to a point where it can be torn off.
To use the pull tractor with the front tractor, follow these steps:
1. Turn on the printer and open the top cover.
4-5-11
6
R
Peony Rev.C
A5 size Chapter 6
98/01/07 Pass 4
Using Printer Options 6-5