Filter
Top Products
4. If you are connecting the parallel interface, squeeze the wire
clips together until they lock in place on either side of the
connector. If your cable has a ground wire, connect it to the
printer’s ground connector as shown below.
If you are connecting the serial interface, fasten the screws
on the cable connector. (If your cable has a ground wire,
connect it to the printer’s ground connector as shown
above.)
Note:
If the screws that come with the cable do not fit into the connector
lock nuts on the interface, replace the lock nuts with the optional
lock nuts provided with the printer.
D-1-22-A
D-1-22-B
1
R
Peony Rev.C
A5 size Chapter 1
98/01/07 Pass 4
Setting Up the Printer 1-13